6' or 8' Door Small Stainless Steel Sill Track Cover/Rail Topper

  • Model: SG6701A8
  • Shipping Weight: 1.5lbs
  • 20 Units in Stock

$24.00

Qty Discounts Off Price
1
$24.00
2-3
$22.80
4-5
$22.08
6+
$21.60
Add to Cart:

8' Door Rail Cover Stainless Steel- Repair 6 or 8 foot damaged or corroded patio door track with easy to install The Small  Stainless Steel Sill Track Cover sometimes referred to as "Rail Topper". This product may save your marriage if your wife has to open the hard to move sliding glass patio door. Only ships at 94 inches or Less.

We are only shipping 94 inches or less Products
We Gladly Cut To Your Exact Size Needed
During Check Out at Step 1 of 3 - Delivery Information
At Bottom Of Page "Special Instructions or Comments About Your Order"
"Enter Exact Length Needed Or We Will Ship 94 Inch Piece"

Or Use Our New WEBFORM for questions
WEB FORM CLICK IT

 You will need to use an Epoxy Glue to hold the Small rail Topper in Place in some cases. Make sure you have used a good solvent to clean any oil residue from your old track before using the Epoxy. We will put a 4" line of epoxy on each end and a little bit in the middle. Depending on how close to the ends of your track the damage is, the weight of the door may cause an end to try to curl up if you do not make sure you Epoxy the ends down.

 We personally use and recommend Loctite® Instant-Mix™ Epoxy 5 MIN

Home Depot SKW # 677156
This Part # Does Not Show On The Home Depot Web Site But you can call your local store and check stock with the above part #

We Recommend You Always replace your rollers when you install the rail topper. Rail Topper will not fix your bad wheel bearings.

When ordering we now MUST have exact length cut measurements as we are no longer shipping 96" Exact Products. ONLY 94 inches or Less.

This is the one product I recommend. It is a slightly heaver gauge than the 6' rail topper and will hold up better on the heaver doors with double glazed glass(thermo pane). Can be cut to size(length)

The Rail Cap / Topper is the best selling product we have for Sliding Glass Door Rail Repairs

Please do not buy the cut (3' 4' 5' 6' sections) rail toppers to save a few bucks on shipping others are selling. Always use a one piece full length rail topper unless of course you have a door that has an over 8' long track. Pocket doors with 16' tracks can use 2 - 8' rail toppers. Just ask and we can show you how to use 2 - 8' rail toppers. Our prices and shipping charges are competitive with others selling same product.This product will always ship from Atlanta  Ga. when you request us to cut it for you.

 


This product was added to our catalog on Tuesday 02 September, 2014.

Your IP Address is: 54.198.111.185
Copyright © 2018 Sliding Glass Door Parts